|
Post by discmaster1 on Jan 16, 2006 20:32:25 GMT -5
Hi, I have setup my lantronix uds-10 and configured it to match Raymond's settings as shown in a different thread. When I go to run Q-Link Reloaded it goes to the connect screen, but goes no further. Can someone explain to me how to get my 128D connected to Q-Link Reloaded via a RS-232 and Lantronix UDS-10 device.
Also, will it be possible to use this setup to connect to other C64/128 and PC BBSes?
Thanks John
|
|
MikeAZ1
Full Member
Qlinker of the 80's
Posts: 157
|
Post by MikeAZ1 on Jan 17, 2006 6:05:40 GMT -5
at the screen that says Press F1 to connect type atdt then enter LED on UDS10 should start blinking then hit F1 and it should connect I have a UDS10 and works great on Qlink
MikeAZ1 on Qlink
|
|
|
Post by discmaster1 on Jan 17, 2006 10:54:41 GMT -5
what modem do you have selected? Is it Hayes or Hayes Compatible? When I load Q-Link it loads the cityscape looking screen then goes to the connect screen and just sits there. There is no Press F1, nor do any key presses do anything on this screen. It just sits and nothing happens.
|
|
MikeAZ1
Full Member
Qlinker of the 80's
Posts: 157
|
Post by MikeAZ1 on Feb 11, 2006 22:42:45 GMT -5
Not Hayes compat choose other modemand commnands I believe is the choice and enter atdt <enter> then f1 to connect
|
|