|
Post by RaymondDay on Aug 30, 2005 5:57:19 GMT -5
This works! I had a hard time getting the right RS232 cable I had to make it. I all ready had two 25 pin mail plugs and only hooked up 3 wires pin 2,3 and 7. Send, Get, and ground. I set up the UDS-100 so it has the Remote IP Address in it all ready
When Q-Link comes up I just have to type atdt then press F1 and that's it.
I have not pressed just F1 like in VICE. I don't think it would work. I did not even change the phone number on the Q-Link disk. That I am using from my CMD hard drive.
Well just wanted to let all know this work with out going though a Linux or Windows PC!
|
|
|
Post by Leif Bloomquist on Aug 30, 2005 7:57:32 GMT -5
Nice! That gives hope for BBS Server to work as well ;-)
|
|
|
Post by RaymondDay on Aug 30, 2005 8:36:14 GMT -5
It looks like it will not log out of Q-Link. When I press F5 it does nothing it don't go to BASIC. I guess Q-Link sends the modem some command. With this it would need to send it +++ath0 or I guess I can set up the Lantronix some way to tell it to end some how.
But it must get off some how because when I press rest on the commodore and get back on I can type the atdt still. If the Lantronix was still connected the atdt would do nothing.
In the Lantronix Properties under:
5. Disconnection Disconnect With EOT False Disable Hard Disconnect False Inactivity Timeout 00:00
If I changed one or both to True would that make the F5 return to basic work?
|
|